Norcros Adhesives | Distributors, Fixers | Tiling Onto A Screed Floor

Tiling Onto A Screed Floor

The first step is to make sure the background surfaces are dry, clean, flat and strong enough to support the tiling. Check for special preparation instructions for your background
Now we’re ready to start mixing the adhesive. Pour cold water into the mixing bucket to the required level for the weight of powder. Gradually add the adhesive, stirring as you go, creating a smooth, lump free consistency. Only mix the amount of adhesive you will be able to use within 30 minutes
Spread the adhesive using a suitable notched trowel
Firmly apply the tiles into the adhesive ribs, using a slight twisting action
It is advised to lift a tile now and again to check the coverage
The adhesive is rapid setting so you can begin grouting 3 hours later

Other How To's

How To

Tiling to cement: sand render walls

PREPARATION The render must be a minimum of 2 weeks old to enable movement caused by drying shrinkage to have taken place. It must be clean, dry and free from dust, laitance or any other contaminants which may act as a release agent, preventing the adhesive from bonding to the render. If the render is […]

How To

Tiling to plasterboard walls

PREPARATION Plasterboard should be dry, securely fixed and rigid with no protruding fixings with the face to receive decorative finishes exposed. It should be a minimum 12.5mm thick when fixed to timber framing or battening and fixed in accordance with the manufacturers recommendations. The maximum weight of tiling which plasterboard is able to support is […]