Tiling Onto A Screed Floor

  1. The first step is to make sure the background surfaces are dry, clean, flat and strong enough to support the tiling. Check for special preparation instructions for your background
  2. Now we’re ready to start mixing the adhesive. Pour cold water into the mixing bucket to the required level for the weight of powder. Gradually add the adhesive, stirring as you go, creating a smooth, lump free consistency. Only mix the amount of adhesive you will be able to use within 30 minutes
  3. Spread the adhesive using a suitable notched trowel
  4. Firmly apply the tiles into the adhesive ribs, using a slight twisting action
  5. It is advised to lift a tile now and again to check the coverage
  6. The adhesive is rapid setting so you can begin grouting 3 hours later

Other How To's

How To

How to Grout Mosaic Tiles

How to Grout Mosaic Tiles We collaborated with House of Mosaics to create this simple step by step informative guide to grouting mosaic tiles. What is Grout? Grout is a type of mortar that fills in the gaps between tiles. This prevents moisture and dirt from getting between and behind the tiles. Grout also gives your entire […]

How To

How to use Norcros Adhesives Wet Seal Tanking Membrane

Application for Walls:1. Dilute the primer 1:2 with water and brush apply on to the area to be tanked. 2. Allow to dry. 3. With a suitable brush, apply Norcros Wet Seal Liquid to internal and external corners, junctions between walls andfloors, junctions between boards and/or different substrates, areas where pipes penetrate, and any small […]

Technical Support

For technical information about Norcros Adhesive products please call:

01782 524140

Technical Support

Technical Support

For technical information about Norcros Adhesive products please call: 01782 524140

tick

CPD videos

View videosContinuous professional development videos